Farm Table Assembly Instructions
This is a step-by-step guide to assembling our Rough Cut Oak Farm Table. Requires 2 people.
Required Tools:
Tape Measure
Hammer
Drill or Impact Driver with a #2 square bit
Before you begin: Remove any packaging material and separate the pieces. You should have the following pieces:
Step 1: Flip the table top upside down. Place a blanket or some form of padding underneath of the top if placing on a hard surface.
Step 2: Place the legs approximately 12” from each end of the table. Add the stretcher piece and gently insert the pegs to hold the stretcher in place. Do not hammer the pegs at this time.
Step: 3: With a tape measure, center the legs on the bottom of the table. Once centered hold each leg and screw them to the tabletop with the provided screws.
Step 4: Hammer the pegs into the stretcher until tight. Be careful not to crack the end of the stretcher.
Step 5: Tilt the table on its side, then lift it onto its feet.
